The Ginny Midge is an excellent midge pattern, especially in smaller sizes, for those finicky fish.
Click Fly to Enlarge
|Hook:||Wet fly or nymph, Sizes 8-20.
|Tail:||Hair's Mask guard hairs.
|Body:||Hair's Mask dubbing with guard hair picked out.
|Ribbing:||Gold oval or flat tinsel.
|Thorax:||Hair's Mask with guard hairs.
|Wing Case:||Turkey tail fibers or Pheasant tail fibers.
Fish the GRHE any where in the water column under a small indicator or as the bottom fly of a two fly rig.
- Start the thread a short way behind the eye and wrap in close turns to the end of the shank.
- Tie in a small bunch of guard hair to form a tail. Catch in the hair on the near side of the shank and while holding the bunch firmly allow it to roll up on top of the shank. Wrap the thread forward in touching turns being careful to keep the hair butts in line with the shank.
- Cut away the waste hair and run the thread back to the base of the tail. Catch in the tinsel to the side of the shank and wrap the thread back toward the eye securing the tinsel aligned to the shank. Return the thread to the base of the tail.
- Dub the thread with a blend of hare’s ear fur to form a tapered rope.
- Wrap the dubbed thread forward to form a tight tapered body.
- Hold the thread one half turn beyond the point where the bobbin hangs at the front of the body, then tease the waste fur from the thread. Put the waste fur to one side for future use. Counter wind the rib.
- With two firm wraps of thread secure the rib, either to one side or at the bottom of the shank. Cut away the waste tinsel.
- Tie in a small bunch of hen pheasant tail fibers by their tips on top of the hook just at the front of the body.
- Dub the thread with a course mix of hare’s ear fur and wrap a spiky but tight thorax.
- Bring the pheasant fibers forward over the thorax and while holding with moderate tension secure the feather with a couple tight wraps of thread.
- Cut away the waste feather fibers and make a three turn whip finish.
- Add a few drops of head cement. When the cement is dry, if you prefer, you can pick out the fur to produce a more ‘shaggy’ profile. This is best done with a piece of Velcro.
Flies or materials are available at T. Hargrove Fly Fishing, Inc.
Saint Louis, Missouri 63144
© 2015 All rights reserved